White Papers

L2Qos 1
L2PT 0
IpMacAcl 0
VmanQos 0
VmanDualQos 0
EcfmAcl 0
nlbclusteracl 0
FcoeAcl 0
iscsiOptAcl 0
ipv4pbr 0
vrfv4Acl 0
Openow 0
fedgovacl 0
Re-Allocating CAM for Ingress ACLs and QoS
The default CAM allocation settings for ingress ACL and QoS regions are shown in the following list.
• L2 ACL(l2acl): 4
• L3 ACL (ipv4acl): 4
• IPv6 L3 ACL (ipv6acl): 0
• L3 QoS (ipv4qos): 2
• L2 QoS (l2qos): 1
• L2PT (l2pt): 0
• MAC ACLs (ipmacacl): 0
• ECFMACL (ecfmacl): 0
• VMAN QoS (vman-qos): 0
• VMAN Dual QoS (vman-dual-qos): 0
• FCoE ACL (fcoeacl): 2
• iSCSI Opt ACL (iscsioptacl): 0
Enter the ipv6acl and vman-dual-qos allocations as a factor of 2 (2, 4, 6, 8, 10). All other CAM regions can use either even or odd
numbered numbers.
NOTE
: On the S5000, there can be only one odd number of Blocks in the CLI conguration; the other Blocks must be in factors
of 2. For example, a CLI conguration of 5+4+2+1+1 Blocks is not supported; a conguration of 6+4+2+1 Blocks is supported.
You must save the new CAM settings to the
startup-cong (write-mem or copy run start) then reload the system for the new
settings to take eect.
To recongure the memory regions on the S5000 used for ingress ACLs and QoS, follow these steps.
1 Enter a CAM allocation action to perform on ingress ACLs.
Content Addressable Memory (CAM)
235