Users Guide
Version 8.3.19.0 Introduced on the S4820T.
Version 8.4.2.1 Introduced on the C-Series and S4810.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
show ip bgp ipv6 unicast extcommunity-list
View information on all routes with Extended Community attributes.
Syntax
show ip bgp ipv6 unicast extcommunity-list [list name]
Parameters
list name Enter the extended community list name you wish to view.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.4.2.1 Introduced on the C-Series and S4810.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
Usage Information
To view the total number of COMMUNITY attributes found, use the show ip bgp ipv6 unicast
summary command. The text line above the route table states the number of COMMUNITY attributes
found.
The show ip bgp ipv6 unicast community command without any parameters lists BGP routes
with at least one BGP community attribute and the output is the same as for the show ip bgp ipv6
unicast
command output.
show ip bgp ipv6 unicast lter-list
View the routes that match the lter lists.
Syntax
show ip bgp ipv6 unicast filter-list as-path-name
IPv6 Border Gateway Protocol (IPv6 BGP)
971