Users Guide

Defaults Disabled.

Command Modes ROUTER BGPV6-ADDRESS FAMILY

Command History

This guide is platform-specic. For command information about other platforms, refer to the relevant Dell

Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version 8.3.19.0 Introduced on the S4820T.

Version 8.4.2.1 Introduced on the C-Series and S4810.

Version 8.2.1.0 Introduced on the E-Series ExaScale.

Version 7.4.1.0 Introduced on the E-Series TeraScale.

Usage Information If you congure the set ipv6 next-hop command in ROUTE-MAP mode, its conguration takes

precedence over the neighbor next-hop-self command.

neighbor peer-group (assigning peers)

Allows you to assign one peer to a existing peer group.

Syntax

neighbor ipv6-address peer-group peer-group-name

To delete a peer from a peer group, use the no neighbor ipv6-address peer-group peer-

group-name command.

Parameters

ipv6-address Enter the IPv6 address in the x:x:x:x::x format.

NOTE: The :: notation species successive hexadecimal elds of zeros.

peer-group peer-

group-name

Enter the keywords peer-group followed by the name of a congured peer

group (maximum 16 characters).

Defaults Not congured.

Command Modes ROUTER BGP