Users Guide
prex-list-name Enter the name of an established prex list. If the prex list is not congured, the
default is permit (to allow all routes).
in Enter the keyword in to distribute only inbound trac.
out Enter the keyword out to distribute only outbound trac.
Defaults Not congured.
Command Modes ROUTER BGPV6-ADDRESS FAMILY
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.4.2.1 Introduced on the C-Series and S4810.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
Related Commands
neighbor lter-list – assigns a AS-PATH list to a neighbor or peer group.
neighbor route-map – assigns a route map to a neighbor or peer group.
neighbor ebgp-multihop
Attempt and accept BGP connections to external peers on networks that are not directly connected.
Syntax
neighbor {ipv6-address | peer-group-name} ebgp-multihop [ttl]
To disallow and disconnect connections, use the no neighbor {ipv6-address | peer-group-
name} ebgp-multihop [ttl] command.
Parameters
ipv6-address Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation species successive hexadecimal elds of zeros.
peer-group-name Enter the name of the peer group.
ttl (OPTIONAL) Enter the number of hops as the time to live (ttl) value. The range is
from 1 to 255. The default is 255.
Defaults Disabled.
Command Modes ROUTER BGP
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Dell Networking OS Command Line Reference Guide.
944
IPv6 Border Gateway Protocol (IPv6 BGP)