Users Guide
debug ip bgp events
Allows you to view information on local BGP state changes and other BGP events.
Syntax
debug ip bgp [ipv6-address | peer-group peer-group-name] events [in | out]
To disable debugging, use the no debug ip bgp ipv6-address | peer-group peer-group-
name] events command.
Parameters
ipv6-address (OPTIONAL) Enter the IPv6 address in the x:x:x:x::x format then the prex length
in the /x format. The range is from /0 to /128.
NOTE: The :: notation species successive hexadecimal elds of zeros.
peer-group peer-
group-name
Enter the keywords peer-group then the name of the peer group.
in (OPTIONAL) Enter the keyword in to view only information on inbound BGP
routes.
out (OPTIONAL) Enter the keyword out to view only information on outbound BGP
routes.
Command Modes EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.4.2.1 Introduced on the C-Series and S4810.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
Usage Information
Entering a no debug ip bgp command removes all congured debug commands for BGP.
debug ip bgp ipv6 dampening
View information on dampened (non-active) IPv6 routes.
Syntax
debug ip bgp ipv6 unicast dampening [in | out]
To disable debugging, use the no debug ip bgp ipv6 unicast dampening command.
Parameters
in (OPTIONAL) Enter the keyword in to view only inbound dampened routes.
IPv6 Border Gateway Protocol (IPv6 BGP)
931