Users Guide

• peer-group-name of the neighbor peer group
restart-time
seconds
Enter the keywords restart-time then the maximum number of seconds
needed to restart and bring up all peers. The range is from 1 to 3600 seconds. The
default is 120 seconds.
stale-path-time
seconds
Enter the keywords stale-path-time then the maximum number of seconds
to wait before restarting a peer’s stale paths. The default is 360 seconds.
role receiver-only Enter the keywords role receiver-only to designate the local router to
support graceful restart as a receiver only.
Defaults As above
Command Modes ROUTER BGP
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
Dell Networking OS
Version 8.3.19.0 Introduced on the S4820T.
Version 8.4.2.1 Introduced on the C-Series and S4810.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
Usage Information This feature is advertised to BGP neighbors through a capability advertisement. In Receiver Only mode, BGP
saves the advertised routes of peers that support this capability when they restart.
bgp log-neighbor-changes
Enable logging of BGP neighbor resets.
Syntax
bgp log-neighbor-changes
To disable logging, use the no bgp log-neighbor-changes command.
Defaults Enabled.
Command Modes ROUTER BGP
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.4.2.1 Introduced on the C-Series and S4810.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
918
IPv6 Border Gateway Protocol (IPv6 BGP)