Users Guide

Version Description
9.7(0.0) Added support for NFS mount.
9.2(1.0) Introduced on the Z9500.
9.0(0.0) Added support for IPv6 for the file-url parameter.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000. Added support for the SSD on the Z9000 only.
8.3.7.0 Introduced on the S4810.
7.7.1.0 Added support for TFTP and SCP.
7.6.1.0 Introduced on the S-Series.
Usage Information
RFC 3986 species that IPv6 host addresses in a uniform resource identier (URI) must be enclosed in square brackets, [X:X:X:X::X]. For maximum exibility this command accepts IPv6 host addresses with or without the square brackets.
After you upgrade the system image, by entering the command. specify the location where the Dell Networking OS image used to boot the system is stored (boot system), save the conguration to the start-up cong le (write memory), and reload the system (reload).
Example
Dell# upgrade system tftp://10.11.8.12/dv-rainier-13 a:
00:39:32 : Discarded 1 pkts. Expected block num : 51. Received block num: 50
!00:39:36 : Discarded 1 pkts. Expected block num : 65. Received block num: 64
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!..............................................................................................................................................................................................!
93924044 bytes successfully copied
System image upgrade completed successfully.
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
Image upgraded to all
upgrade
Upgrade the bootash image or system image of the management unit.
Syntax
upgrade {boot | system} {ftp: | scp: | tftp: | flash: {A: |B:} | stack-unit | usbflash | slot0:}
file-url
Parameters
boot Enter the keyword boot to change the boot image.
system Enter the keyword system to change the system image.
ftp: After entering the keyword ftp:, you can either follow it with the location of the source le in this form: //
userid:password@hostip/filepath or press Enter to launch a prompt sequence.
scp: After entering the keyword scp:, you can either follow it with the location of the source le in this form: //
userid:password@hostip/filepath or press Enter to launch a prompt sequence.
slot0: After entering the keyword slot0:, you can either follow it with the location of the source le in this form: //
hostlocation/filepath or press Enter to launch a prompt sequence.
tftp: After entering the keyword tftp:, you can either follow it with the location of the source le in this form: //
hostlocation/filepath or press Enter to launch a prompt sequence.
ash: After entering the keyword flash:, you can either follow it with the location of the source le in this form: flash//
filepath or press Enter to launch a prompt sequence.
A: | B: Enter the partition to upgrade from the ash.
File Management
89