Users Guide
seq 10 permit icmp host 3333:: any mobile-advertisement log
seq 15 deny tcp any any rst
seq 20 permit udp any any gt 100 count
Dell#
test cam-usage
Verify that enough ACL CAM space is available for the IPv6 ACLs you have created.
C9000
Syntax
test cam-usage service-policy input input policy name linecard {number |
all}
Parameters
policy-map name Enter the name of the policy-map to verify.
number Enter all to get information for all the linecards, or enter the linecard number to
get information for a specic card. The range is 0-6 for E-Series and 0-7 for C-
Series.
Defaults none
Command Modes EXEC Privilege
Command History
Version 9.0.2.0 Introduced on the S6000.
Version 8.4.2.1 Introduced on the S-Series.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.8.1.0 Introduced on the C-Series and E-Series TeraScale.
Usage Information
This command applies to both IPv4 and IPv6 CAM Proles, but is best used when verifying QoS
optimization for IPv6 ACLs.
QoS Optimization for IPv6 ACLs does not impact the CAM usage for applying a policy on a single (or the
rst of several) interfaces. It is most useful when a policy is applied across multiple interfaces; it can reduce
the impact to CAM usage across subsequent interfaces.
The following describes the test cam-usage command shown in the Example below.
Term Explanation
Linecard Lists the line card or linecards that are checked. Entering all shows the status for
linecards in the chassis.
Portpipe Lists the portpipe (port-set) or port pipes (port-sets) that are checked. Entering
all shows the status for linecards and port-pipes in the chassis.
CAM Partition Shows the CAM prole of the CAM.
Available CAM Identies the amount of CAM space remaining for that prole.
Estimated CAM per
Port
Estimates the amount of CAM space the listed policy requires.
IPv6 Access Control Lists (IPv6 ACLs)
877