Users Guide

• Use the no permit tcp {source address mask | any | host ipv6-address}
{destination address | any | host ipv6-address} command.
Parameters
source address Enter the IPv6 address of the network or host from which the packets were sent in
the x:x:x:x::x format followed by the prex length in the /x format. The range is /0
to /128. The :: notation species successive hexadecimal elds of zero.
mask Enter a network mask in /prex format (/x).
any Enter the keyword any to specify that all routes are subject to the lter.
host ipv6-address Enter the keyword host followed by the IPv6 address of the host in the x:x:x:x::x
format. The :: notation species successive hexadecimal elds of zero.
operator (OPTIONAL) Enter one of the following logical operand:
• eq = equal to
• neq = not equal to
• gt = greater than
• lt = less than
• range = inclusive range of ports (you must specify two port for the port
parameter.)
port port Enter the application layer port number. Enter two port numbers if using the range
logical operand. The range is 0 to 65535.
The following list includes some common TCP port numbers:
• 23 = Telnet
• 20 and 21 = FTP
• 25 = SMTP
• 169 = SNMP
destination address Enter the IPv6 address of the network or host to which the packets are sent in the
x:x:x:x::x format followed by the prex length in the /x format. The range is /0 to /
128. The :: notation species successive hexadecimal elds of zero.
bit Enter a ag or combination of bits:
• ack: acknowledgement eld
• fin: nish (no more data from the user)
• psh: push function
• rst: reset the connection
• syn: synchronize sequence numbers
• urg: urgent eld
count (OPTIONAL) Enter the keyword count to count packets processed by the lter.
byte (OPTIONAL) Enter the keyword byte to count bytes processed by the lter.
Defaults Not congured.
Command Modes ACCESS-LIST
Command History
Version 9.0.2.0 Introduced on the S6000.
IPv6 Access Control Lists (IPv6 ACLs)
865