Users Guide

To delete an IPv6 access-group conguration, use the no ipv6 access-group access-list-name
{in} [implicit-permit] [vlan range] command.
Parameters
access-list-name Enter the name of a congured access list, up to 140 characters.
in | out Enter either the keyword in or out to apply the IPv6 ACL to incoming trac
(ingress) or outgoing trac (egress).
implicit-permit (OPTIONAL) Enter the keywords implicit-permit to change the default
action of the IPv6 ACL from implicit-deny to implicit-permit (that is, if the trac
does not match the lters in the IPv6 ACL, the trac is permitted instead of
dropped).
vlan range (OPTIONAL) Enter the keyword vlan followed by the VLAN range in a comma
separated format. The range is 1 to 4094.
Defaults Disabled.
Command Modes INTERFACE
Command History
Version 9.0.2.0 Introduced on the S6000.
Version 8.4.2.1 Introduced on the S-Series.
Version 7.8.1.0 Introduced on the C-Series. Increased the name string to accept up to 140
characters. Prior to version 7.8.1.0, names are up to 16 characters long.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
Usage Information You can assign an IPv6 access group to a physical, LAG, or VLAN interface context.
Example
Dell(conf-if-gi-9/0)#ipv6 access-group AclList1 in implicit-permit vlan
10-20
Dell(conf-if-gi-9/0)#show config
!
interface GigabitEthernet 9/0
no ip address
ipv6 access-group AclList1 in implicit-permit Vlan 10-20
no shutdown
Dell(conf-if-gi-9/0)#
ipv6 control-plane egress-lter
Enable egress Layer 3 ACL lookup for IPv6 CPU trac.
Syntax
ipv6 control-plane egress-filter
Defaults Not enabled.
Command Modes EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
IPv6 Access Control Lists (IPv6 ACLs)
861