Users Guide

tcp-udp enable Enter the keywords to distribute trac based on the following:
• enable — Takes the TCP/UDP source and destination ports into
consideration when doing hash computations. (By default, this is enabled.)
ingress-port enable Enter the keywords to distribute trac based on the following:
• enable — Takes the source port into consideration when doing hash
computations. (By default, this is disabled.)
Defaults IP 4-tuple (IP SA, IP DA, Source Port, Destination Port)
Command Modes CONFIGURATION
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage Information By default, Dell Networking OS distributes incoming trac based on a hash algorithm using the following
criteria:
• IP source address
• IP destination address
• TCP/UDP source port
• TCP/UDP destination port
Related Commands hash-algorithm ecmp – changes the hash algorithm across an ECMP.
management route
Congure a static route that points to the Management interface or a forwarding router.
Syntax
management route {{ip-address mask | {ipv6-address prefix-length}}
{forwarding-router-address | managementethernet | fortyGigE | vlan |
tengigabitethernet}
To remove a static route, use the no management route{{ip-address mask | {ipv6-address
prefix-length}}{forwarding-router-address | managementethernet | fortyGigE
| vlan | gigabitethernet | tengigabitethernet} command.
Parameters
ip-address mask Enter an IP address (dotted decimal format) and mask (/prex format) of the
destination subnet.
ipv6-address prex-
length
Enter an IPv6 address (x:x:x:x::x format) and mask (/prex format) of the
destination subnet. Enter the IPv6 address in the x:x:x:x::x format followed by the
prex length in the /x format.
The range is from /0 to /128.
NOTE: The :: notation species successive hexadecimal elds of zeros.
824
IPv4 Routing