Users Guide

To disable proxy ARP, use the no ip proxy-arp command.
Defaults Enabled.
Command Modes INTERFACE
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced on the E-Series.
Related Commands show ip interface — displays the interface routing status and conguration.
ip route
Assign a static route to the switch.
Syntax
ip route ip-address mask {ip-address | interface [ip-address]} [distance]
[permanent] [tag tag-value] [vrf vrf-name] [weight weight-value]
To delete a specic static route, use the no ip route destination mask command.
To delete all routes matching a certain route, use the no ip route destination mask command.
Parameters
destination Enter the IP address in dotted decimal format of the destination device.
mask Enter the mask in the slash prex format (/x) of the destination IP address.
ip-address Enter the IP address of the forwarding router in dotted decimal format.
interface Enter one of the following keyword followed by the slot/port number:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
IPv4 Routing
819