Users Guide

ip udp-helper udp-port — enables the UDP broadcast feature on an interface.
show ip udp-helper — displays the congured UDP helper(s) on all interfaces.
ip udp-broadcast-address
Congure an IP UDP address for broadcast.
Syntax
ip udp-broadcast-address address
To delete the conguration, use the no ip udp-broadcast-address address command.
Parameters
address Enter an IP broadcast address in dotted decimal format (A.B.C.D).
Defaults Not congured.
Command Modes INTERFACE (cong-if)
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
8.3.19.0 Introduced on the S4820T.
8.3.7.0 Introduced on the S4810.
Pre-version 8.3.7.0 Introduced on the E-Series ExaScale.
Usage Information When a UDP broadcast packet is ooded out of an interface, and the outgoing interface is congured using
this command, the outgoing packet’s IP destination address is replaced with the congured broadcast
address.
Related Commands
debug ip udp-helper — enables debug and displays the debug information on a console.
show ip udp-helper — displays the congured UDP helpers on all interfaces.
ip udp-helper udp-port
Enable the UDP broadcast feature on an interface either for all UDP ports or a specied list of UDP ports.
Syntax
ip udp-helper udp-port [udp-port-list]
To disable the UDP broadcast on a port, use the no ip udp-helper udp-port [udp-port-list]
command.
Interfaces
755