Users Guide

tdr-cable-test
Test the condition of copper cables on 10G Base-T modules.
S5000
Syntax
tdr-cable-test interface
Parameters
interface Enter the keyword TenGigabitEthernet then the slot/port information for the
10G Ethernet interface.
Defaults none
Command Modes EXEC
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7.0.0 Introduced on the S5000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced on the E-Series ExaScale.
7.7.1.0 Introduced on the S Series.
7.6.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
Usage Information The interface must be enabled to run the test or an error message is generated:
Dell#tdr-cable-test tengigabitethernet 11/1
% Error: Interface is disabled Te 11/1.
Syslog messages are generated when the link aps during TDR tests.
Related Commands show tdr — displays the results of the TDR test.
show tdr
Display the TDR test results.
S5000
Syntax
show tdr interface
Parameters
interface Enter the keyword TenGigabitEthernet then the slot/port information for the
10G Ethernet interface.
Defaults none
752
Interfaces