Users Guide

Usage Information This command applies to any physical interface with speed set to 10/100.
NOTE: Starting with Dell Networking OS version 7.8.1.0, when you use a copper SFP2 module with
catalog number GP-SFP2-1T in the S25P model of the S-Series, you can manually set its speed
with the speed command. When you set the speed to 10 Mbps or 100 Mbps, you can also execute
the duplex command.
Related Commands
negotiation auto — enables or disables auto-negotiation on an interface.
duplex (Management interface)
Congure duplex mode on a management interface whose speed is set to 10/100 Mb/s.
S5000
Syntax
duplex {half | full}
To return to the default setting, use the no duplex command.
Parameters
half Enter the keyword half to set the physical interface to transmit only in one
direction.
full Enter the keyword full to set the physical interface to transmit in both directions.
Defaults Not congured.
Command Modes INTERFACE
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage Information This command applies only to management interfaces with speed set to 10/100 Mb/s using the speed
command.
NOTE: When you set the speed to 10 or 100 Mbps, you can also execute the duplex command.
Related Commands interface ManagementEthernet — congures the Management port on the system (either the primary or
standby stack-unit).
owcontrol
Control how the system responds to and generates 802.3x pause frames on 10 Gig ports.
Syntax
flowcontrol rx {off | on} tx {off | on}
Parameters
rx on Enter the keywords rx on to process the received ow control frames on this port. This is the
default value for the receive side.
rx o Enter the keywords rx off to ignore the received ow control frames on this port.
682
Interfaces