Users Guide
VRRP Mode
To enable and congure Virtual Router Redundancy Protocol (VRRP), use VRRP mode. For more information, refer to Virtual Router
Redundancy Protocol (VRRP).
To enter VRRP mode:
1. To enable VRRP globally, verify that you are logged in to CONFIGURATION mode.
2. Enter the vrrp-group command then enter the VRRP group ID. The prompt changes to include (conf-if-interface-type-slot/
port-vrid-vrrp-group-id).
Determining Chassis Mode
Chassis mode in Dell Networking OS determines which hardware is being supported in an E-Series chassis.
Chassis mode is programmed into an electrically erasable programmable read-only memory (EEPROM) on the backplane of the
chassis and the change takes place only after the chassis is rebooted. Conguring the appropriate chassis mode allows the system
to use all the ports on the card and recognize all software features.
CLI Basics
63