Users Guide
Version Description
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced on the C-Series and S-Series.
Usage Information Entering <CR> after the clear ip dhcp binding command clears all the IPs from the binding table.
debug ip dhcp server
Display FTOS debugging messages for DHCP.
Syntax
debug ip dhcp server [events | packets]
Parameters
events Enter the keyword events to display the DHCP state changes.
packet Enter the keyword packet to display packet transmission/reception.
Defaults none
Command Modes EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced on the C-Series and S-Series.
default-router
Assign a default gateway to clients based on the address pool.
Syntax
default-router address [address2...address8]
Parameters
address Enter a list of routers that may be the default gateway for clients on the subnet.
You may specify up to eight routers. List them in order of preference.
Defaults none
Command Modes DHCP <POOL>
564
Dynamic Host Conguration Protocol (DHCP)