Users Guide
Version 8.3.7.0 Introduced on the S4810.
Version 8.3.1.0 Added the keywords ecfmacl, vman-qos, and vman-dual-qos.
Version 8.2.1.0 Introduced on the S-Series.
Version 7.8.1.0 Introduced on the C-Series.
Usage Information
You must save the new CAM settings to the startup-cong (write-mem or copy run start) then
reload the system for the new settings to take eect.
There are four groups total. You must allocate at least one group for L2ACL and IPv4 ACL.
The range for the CAM proles are 1 to 4 for l2acl. The range for the ipv6acl prole is 0 to 10. The
ipv6acl allocation must be a factor of 2 (2, 4, 6, 8, 10).
cam-optimization
Optimize CAM utilization for QoS Entries by minimizing require policy-map CAM space.
Syntax
cam-optimization [qos]
Parameters
qos Optimize CAM usage for QoS.
Defaults Disabled.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced on the S-Series.
7.8.1.0 Introduced on the C-Series.
Usage Information When you enable this command, if a Policy Map containing classication rules (ACL and/or dscp/ ip-
precedence rules) is applied to more than one physical interface on the same port pipe, only a single copy of
the policy is written (only one FP entry is used).
Content Addressable Memory (CAM)
509