Users Guide

Version Description
9.4.(0.0) Added support for PBR and VRF.
9.2(0.2) Added support for fcoe.
9.1.(0.0) Added support for OpenFlow.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.10.2 Claried block information for the S4810.
8.3.10.0 Introduced on the S4810.
8.3.1.0 Added the keywords ecfmacl, vman-qos, and vman-dual-qos.
8.2.1.0 Introduced on the S-Series.
7.8.1.0 Introduced on the C-Series.
Usage Information
Save the new CAM settings to the startup-cong (write-mem or copy run start) then reload the
system for the new settings to take eect.
The total amount of space allowed is 16 FP Blocks. System ow requires three blocks; these blocks cannot
be reallocated. Only 13 number of blocks can be congured by the user .
The ipv6acl allocation must be a factor of 2.
If allocation values are not entered for the CAM regions, the value is 0.
If you enable BMP, to perform a reload on the chassis to upgrade any conguration changes that have
changed the NVRAM content, use the command reload conditional nvram-cfg-change.
cam-acl-egress (Conguration)
Select the FP groups for CAM access control lists for Layer 2, IPv4, and IPv6 ACLs.
Syntax
cam-acl-egress {default | l2acl number ipv4acl number ipv6acl number}
Parameters
default Reset the egress CAM ACL entries to the default settings.
l2acl number
ipv4acl number
ipv6acl number
Allocate space to each CAM region.
Enter the CAM prole name followed by the amount of CAM space to be allotted.
The total space allocated must equal 13. The l2acl range is 1 to 4. The ipv4acl range
is 1 to 4. The ipv6acl range is 0 to 4.
Command Modes CONFIGURATION
Command History
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
508
Content Addressable Memory (CAM)