Users Guide

cong-scr-
download {enable}
(Optional.) Congure whether the conguration le must be downloaded from the
DHCP/le servers (enable).
cong-download
{disable}
(Optional.) Congure if the downloaded le will not be downloaded from the
DHCP/le servers.
dhcp-timeout
minutes
(Optional) Congure the DHCP timeout (in minutes) after which the BMP reload
stops. The range is from 0 to 50. If a range of 0 is entered, the timeout is 0 (no
limit). The default is disabled.
NOTE:
Dell Networking recommends setting the value to 2 or higher.
retry-count number Congure the number of times to retry loading the Dell Networking OS image and
conguration download. The retry limit is 0–6. If the retry limit is 0, no retry is
performed. The default is 0.
vendor-class-
identier
description
(Optional) Enter a brief description for DHCP Option 60. Maximum is 64 characters
long.
NOTE:
This parameter replaces the deprecated parameter user-dened-string.
Defaults BMP
Switches running BMP 3.0 reload in BMP mode as a DHCP client with all ports congured for Layer 3 trac.
Command Modes GLOBAL CONFIGURATION
Command History
Version 9.0.2.0 Introduced on the S6000.
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is supported in Programmable-
Mux (PMUX) mode only.
Version 9.2(0.0) Introduced support for vendor-class-identifier that replaces deprecated
parameter user-defined-string Also added support for retry-count.
Version 9.1(0.0) Introduced on the Z9000. Updated the command mode from EXEC Privilege to
GLOBAL CONFIGURATION. Updated the parameter from jumpstart to bmp.
Added support for the config-scr-download and user-defined-string
commands.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.1.0 Introduced on the S4810.
Usage Information For an initial setup, the config-scr-download parameter of the reload-type command is enabled.
After the conguration le is successfully downloaded, the config—scr-download parameter is
automatically disabled. You can enable it again using the
reload-type command.
Set the Auto Conguration mode (BMP or Normal reload) using the reload-type command. Next, enter
the reload command to reload the switch in the congured mode.
When a switch reloads in BMP mode, all ports, including the management port, are automatically congured
as Layer 3 physical ports. The switch runs DHCP client on all interfaces. You can recongure the default
startup conguration and DHCP timeout values.
502
Bare Metal Provisioning (BMP)