Users Guide

ROUTE_REFRESH(2)
CISCO_ROUTE_REFRESH(128)
Update source set to Loopback 0
For address family: IPv4 Multicast
BGP table version 14, neighbor version 14
3 accepted prefixes consume 12 bytes
Prefixes accepted 1 (consume 4 bytes), withdrawn 0 by peer
Prefixes advertised 0, rejected 0, withdrawn 0 from peer
Connections established 2; dropped 1
Last reset 00:03:17, due to user reset
Notification History
'Connection Reset' Sent : 1 Recv: 0
Local host: 100.10.10.1, Local port: 179
Foreign host: 25.25.25.25, Foreign port: 2290
BGP neighbor is 211.1.1.129, remote AS 640, external link
BGP version 4, remote router ID 0.0.0.0
BGP state ACTIVE, in this state for 00:00:36
Last read 00:00:41, hold time is 180, keepalive interval is 60 seconds
Received 28 messages, 0 notifications, 0 in queue
Sent 6 messages, 3 notifications, 0 in queue
Received 18 updates, Sent 6 updates
Route refresh request: received 0, sent 0
Minimum time between advertisement runs is 30 seconds
For address family: IPv4 Multicast
BGP table version 14, neighbor version 0
0 accepted prefixes consume 0 bytes
Prefix advertised 0, rejected 0, withdrawn 0
Connections established 3; dropped 3
Last reset 00:00:37, due to user reset
Notification History
'Connection Reset' Sent : 3 Recv: 0
Related Commands
show ip bgp – views the current BGP routing table.
show ip bgp peer-group
Allows you to view information on the BGP peers in a peer group.
C-Series, E-Series TeraScale, S-Series
Syntax
show ip bgp ipv4 multicast peer-group [peer-group-name [detail | summary]]
Parameters
peer-group-name (OPTIONAL) Enter the name of a peer group to view information about that peer
group only.
detail (OPTIONAL) Enter the keyword detail to view detailed status information of the
peers in that peer group.
summary (OPTIONAL) Enter the keyword summary to view status information of the peers
in that peer group. The output is the same as that found in the show ip bgp
summary
command.
Border Gateway Protocol
487