Users Guide

Version 7.7.1.0 Introduced on the C-Series.
show ip bgp ipv4 multicast neighbors
Allows you to view the information exchanged by BGP neighbors.
C-Series, E-Series TeraScale, S-Series
Syntax
show ip bgp ipv4 multicast neighbors [ip-address [advertised-routes |
dampened-routes | detail | flap-statistics | routes]]
Parameters
ip-address (OPTIONAL) Enter the IP address, in either IPv4 or IPv6 format, of the neighbor to
view only BGP information exchanged with that neighbor.
advertised-routes (OPTIONAL) Enter the keywords advertised-routes to view only the routes
the neighbor sent.
dampened-routes (OPTIONAL) Enter the keywords dampened-routes to view information on
dampened routes from the BGP neighbor.
detail (OPTIONAL) Display detailed neighbor information.
ap-statistics (OPTIONAL) Enter the keywords flap-statistics to view ap statistics on
the neighbor’s routes.
routes (OPTIONAL) Enter the keyword routes to view only the neighbor’s feasible
routes.
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Version 7.6.1.0 Introduced IPv6 MGBP on the E-Series.
Usage Information
The following describes the show ip bgp ipv4 multicast neighbors command shown in the
Example below.
Lines beginning
with:
Description
BGP neighbor Displays the BGP neighbor address and its AS number. The last phrase in the line
indicates whether the link between the BGP router and its neighbor is an external
or internal one. If they are located in the same AS, then the link is internal;
otherwise the link is external.
BGP version Displays the BGP version (always version 4) and the remote router ID.
BGP state Displays the neighbor’s BGP state and the amount of time in
hours:minutes:seconds it has been in that state.
Last read This line displays the following information:
Border Gateway Protocol
485