Users Guide

network
Specify the networks for the BGP process and enter them in the BGP routing table.
C-Series, E-Series TeraScale, S-Series
Syntax
network ip-address mask [route-map map-name]
To remove a network, use the no network ip-address mask [route-map map-name]
command.
Parameters
ip-address Enter an IP address in dotted decimal format of the network.
mask
Enter the mask of the IP address in the slash prex length format (for example, /
24).
The mask appears in command outputs in dotted decimal format (A.B.C.D).
route-map map-
name
(OPTIONAL) Enter the keyword route-map followed by the name of an
established route map.
Only the following ROUTE-MAP mode commands are supported:
• match ip address
• set community
• set local-preference
• set metric
• set next-hop
• set origin
• set weight
If the route map is not congured, the default is deny (to drop all routes).
Defaults Not congured.
Command Modes ROUTER BGP Address Family (conf-router_bgp_af)
Command History
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Version 7.6.1.0 Introduced IPv6 MGBP on the E-Series.
Usage Information Dell Networking OS software resolves the network address congured by the network command with the
routes in the main routing table to ensure that the networks are reachable using non-BGP routes and non-
default routes.
Related Commands redistribute – redistributes routes into the BGP.
476
Border Gateway Protocol