Users Guide

Command History
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Version 7.6.1.0 Introduced IPv6 MGBP on the E-Series.
neighbor distribute-list
Distribute BGP information using an established prex list.
Syntax
neighbor [ip-address | peer-group-name] distribute-list prefix-list-name
[in | out]
To delete a neighbor distribution list, use the no neighbor [ip-address | peer-group-name]
distribute-list prefix-list-name [in | out] command.
Parameters
ip-address Enter the IP address of the neighbor in dotted decimal format.
peer-group-name Enter the name of the peer group to apply the distribute list lter to all routers in
the peer group.
prex-list-name
Enter the name of an established prex list.
If the prex list is not congured, the default is permit (to allow all routes).
in Enter the keyword in to distribute only inbound trac.
out Enter the keyword out to distribute only outbound trac.
Defaults Not congured.
Command Modes ROUTER BGP Address Family (conf-router_bgp_af)
Command History
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Version 7.6.1.0 Introduced IPv6 MGBP on the E-Series.
Usage Information Other BGP ltering commands include: neighbor filter-list, ip as-path access-list, and
neighbor route-map.
Related Commands
ip as-path access-list – congures the IP AS-Path ACL.
neighbor lter-list – assigns a AS-PATH list to a neighbor or peer group.
neighbor route-map – assigns a route map to a neighbor or peer group.
Border Gateway Protocol
471