Users Guide

To return to the default value, use the no bgp default local-preference command.
Parameters
value Enter a number to assign to routes as the degree of preference for those routes.
When routes are compared, the higher the degree of preference or local preference
value, the more the route is preferred. The range is from 0 to 4294967295. The
default is 100.
Defaults 100
Command Modes ROUTER BGP
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage Information
All routers apply the bgp default local-preference command setting within the AS. To set the
local preference for a specic route, use the set local-preference command in ROUTE-MAP mode.
Related Commands set local-preference — assigns a local preference value for a specic route.
bgp dmzlink-bw
Enables BGP Link Bandwidth.
S5000
Syntax
bgp dmzlink-bw
To disable BGP Link Bandwidth, enter the no bgp dmzlink-bw command.
Parameters
dmzlink-bw Enter the keyword dmzlink-bw to enable BGP Link Bandwidth in BGP multipath.
Defaults N/A
Command Modes ROUTER BGP
Border Gateway Protocol
365