Users Guide

Parameters
tag-value Enter a value as the tag on which to match. The range is from zero (0) to
4294967295.
Defaults Not congured.
Command Modes ROUTE-MAP
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced on the E-Series.
Related Commands
match interface — redistributes routes that match the next-hop interface.
match ip address — redistributes routes that match an IP address.
match ip next-hop — redistributes routes that match the next-hop IP address.
match ip route-source — redistributes routes that match routes advertised by other routers.
match metric — redistributes routes that match a specic metric.
match route-type — redistributes routes that match a route type.
route-map
Enable a route map statement and congure its action and sequence number. This command also places you in ROUTE-MAP mode.
Syntax
route-map map-name [permit | deny] [sequence-number]
To delete a route map, use the no route-map map-name [permit | deny] [sequence-
number] command.
Parameters
map-name Enter a text string of up to 140 characters to name the route map for easy
identication.
permit (OPTIONAL) Enter the keyword permit to set the route map default as permit. If
you do not specify a keyword, the default is permit.
270
Access Control Lists (ACL)