Users Guide

NOTE: When you congure the ACL logging and byte counters simultaneously, byte counters may
display an incorrect value. Congure packet counters with logging instead.
Related Commands
deny — congures a MAC ACL lter to drop packets.
seq — congure a MAC ACL lter with a specied sequence number.
IP Prex List Commands
When you create an access-list without any rule and then apply it to an interface, the ACL behavior reects implicit permit.
To congure or enable IP prex lists, use these commands.
clear ip prex-list
Reset the number of times trac mets the conditions (“hit” counters) of the congured prex lists.
Syntax
clear ip prefix-list [prefix-name]
Parameters
prex-name (OPTIONAL) Enter the name of the congured prex list to clear only counters for
that prex list, up to 140 characters long.
Defaults Clears “hit” counters for all prex lists unless a prex list is specied.
Command Modes EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.8.1.0 Increase the name string to accept up to 140 characters. Prior to 7.8.1.0, names
were up to 16 characters long.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Related Commands ip prex-list — congures a prex list.
254
Access Control Lists (ACL)