Users Guide

deny Enter the keyword deny to congure a lter to drop packets meeting this
condition.
permit Enter the keyword permit to congure a lter to forward packets meeting this
criteria.
any Enter the keyword any to lter all packets.
mac-source-
address
Enter a MAC address in nn:nn:nn:nn:nn:nn format.
mac-source-
address-mask
(OPTIONAL) Specify which bits in the MAC address must match. If no mask is
specied, a mask of 00:00:00:00:00:00 is applied (in other words, the lter allows
only MAC addresses that match).
count (OPTIONAL) Enter the keyword count to count packets the lter processes.
byte (OPTIONAL) Enter the keyword byte to count bytes the lter processes.
log (OPTIONAL, E-Series only) Enter the keyword log to log the packets.
monitor (OPTIONAL) Enter the keyword monitor when the rule is describing the trac
that you want to monitor and the ACL in which you are creating the rule is applied
to the monitored interface.
NOTE: For more information, refer to the “Flow-based Monitoring” section
in the Port Monitoring chapter of the Dell Networking OS Conguration
Guide
.
no-drop Enter the keywords no-drop to match only the forwarded packets.
Defaults Not congured
Command Modes CONFIGURATION-MAC ACCESS LIST-STANDARD
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Added the no-drop parameter.
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 Added the monitor option.
6.1.1.0 Introduced on the E-Series.
248
Access Control Lists (ACL)