Users Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S5000

211

212

213

214

215

216

217

218

219

220

Command History

This guide is platform-specic. For command information about other platforms, refer to the relevant Dell

Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.7(0.0) Introduced on the S6000–ON.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

8.1.1.0 Introduced on the E-Series ExaScale.

7.8.1.0 Increased the name string to accept up to 140 characters. Prior to 7.8.1.0, names

were up to 16 characters long.

7.6.1.0 Introduced on the S-Series.

7.5.1.0 Introduced on the C-Series.

6.2.1.1 Introduced on the E-Series.

Usage Information You can assign one ACL (standard or extended ACL) to an interface.

NOTE: This command supports Loopback interfaces EE3 and EF series route processor modules

(RPMs). This command does not support Loopback interfaces ED series RPMs and S-Series

Loopback interfaces.

NOTE: If you apply outbound(egress) IP acl on a switch port, the lter applies only for routed

trac egressing out of that port.

Related Commands

ip access-list standard — congures a standard ACL.

ip access-list extended — congures an extended ACL.

ip control-plane egress-lter

Enable egress Layer 3 ACL lookup for IPv4 CPU trac.

Syntax

ip control-plane egress-filter

Defaults Not enabled.

Command Modes EXEC Privilege