Users Guide

Parameters
vrid (OPTIONAL) Enter the virtual router identier for the VRRP group to view only
that group. The range is from 1 to 255.
interface Enter the following keywords and slot/port or number information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a port channel interface, enter the keywords port-channel then a
number.
•
For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
brief (OPTIONAL) Enter the keyword brief to view a table of information on the
VRRP groups.
vrf vrf-name Enter the keyword vrf followed by the name of the VRF to view IPv6 VRRP groups
corresponding to that VRF.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Added support for VRF. Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.10.0 Introduced on the S4810.
8.3.2.0 Introduced on the E-Series TeraScale.
Usage Information The following describes the show vrrp ipv6 command shown in the following example.
Line Beginning
with
Description
GigabitEthernet... Displays the Interface, the VRRP group ID, and the network address. If the
interface is no sending VRRP packets, 0.0.0.0 appears as the network address.
VRF VRF instance to which the interface (on which the VRRP group is congured)
belongs.
State: master... Displays the interface’s state:
• Na/If (not available).
• master (MASTER virtual router).
• backup (BACKUP virtual router).
the interface’s priority and the IP address of the MASTER.
Hold Down:... This line displays additional VRRP conguration information:
Virtual Router Redundancy Protocol (VRRP)
1791