Users Guide

Codes: * - Default VLAN, G - GVRP VLANs
NUM Status Q Ports
* 1 Inactive
2 Active M Te 1/13
M Te 1/1-3
3 Active M Po1(Te 1/14-15)
M Te 1/18
M Te 1/4
4 Active M Po1(Te 1/14-15)
M Te 1/18
M Te 1/5
5 Active M Po1(Te 1/14-15)
M Te 1/18
M Te 1/6
Dell#
vlan-stack dot1p-mapping
Map C-Tag dot1p values to a S-Tag dot1p value. You can separate the C-Tag values by commas and dashed ranges are permitted.
Dynamic mode CoS overrides any Layer 2 QoS conguration in case of conicts.
Syntax
vlan-stack dot1p-mapping c-tag-dot1p values sp-tag-dot1p value
Parameters
c-tag-dot1p value Enter the keyword c-tag-dot1p then the customer dot1p value that is mapped
to a service provider do1p value. The range is from 0 to 7.
sp-tag-dot1p value Enter the keyword sp-tag-dot1p then the service provider dot1p value. The
range is from 0 to 7.
Defaults none
Command Modes INTERFACE
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.7.0 Introduced on the S4810.
8.3.1.0 Introduced on the C-Series and S-Series.
1734
VLAN Stacking