Users Guide

logging on
Specify that debug or error messages are asynchronously logged to multiple destinations, such as the logging buer, Syslog server,
or terminal lines.
Syntax
logging on
To disable logging to logging buer, Syslog server and terminal lines, use the no logging on command.
Defaults Enabled.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage Information When you use the no logging on command, messages are logged only to the console.
Related Commands
logging — enables logging to the Syslog server.
logging buered — sets the logging buered parameters.
logging console — sets the logging console parameters.
logging monitor — sets the logging parameters for the terminal connections.
logging source-interface
Specify that the IP address of an interface is the source IP address of Syslog packets sent to the Syslog server.
Syntax
logging source-interface interface
To disable this command and return to the default setting, use the no logging source-interface
command.
Parameters
interface Enter the following keywords and slot/port or number information:
Simple Network Management Protocol (SNMP) and Syslog
1651