Users Guide
set-ip-dscp value (OPTIONAL) Enter the keywords set-ip-dscp then the IP DSCP value. The
matched trac is marked with the DSCP value. The range is from 0 to 63.
Defaults none
Command Modes CLASS-MAP CONFIGURATION (cong-class-map)
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.5(0.0) Added the ipv6 and ip-any options on the Z9000, S6000, S4820T, S4810, MXL.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
Usage Information
To access this command, enter the class-map command. After the class map is identied, you can
congure the match criteria.
The match ip dscp and match ip precedence commands are mutually exclusive.
Up to 64 IP DSCP values can be matched in one match statement. For example, to indicate IP DCSP values
0 1 2 3 4 5 6 7, enter either the match ip dscp 0,1,2,3,4,5,6,7 or match ip dscp 0-7
command.
NOTE: Only one of the IP DSCP values must be a successful match criterion, not all of the
specied IP DSCP values must match.
Related Commands class-map — identies the class map.
match ip precedence
Use IP precedence values as a match criteria.
Syntax
match {ip | ipv6 | ip-any} precedence ip-precedence-list [set-ip-dscp
value]
To remove IP precedence as a match criteria, use the no match {ip | ipv6 | ip-any}
precedence ip-precedence-list [[multicast] set-ip-dscp value] command.
Parameters
ip Enter the keyword ip to support IPv4 trac.
ipv6 Enter the keyword ipv6 to support IPv6 trac.
1424
Quality of Service (QoS)