Users Guide
Command History
Version Description
9.7(0.0) Introduced on the S6000-ON. Added support for VRF on S6000, S4810, S4820T,
Z9000, Z9500, and S6000–ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.1 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
7.5.1.0 Introduced on the E-Series.
Usage Information
Dell Networking OS supports standard access lists for the SSM range. You cannot use extended ACLs for
conguring the SSM range. If you congure an extended ACL and then used in the ip pim ssm-range
{access list name} conguration, an error is reported.
However, if you congure ip pim ssm-range {access list name} rst and then you congure
the ACL as an Extended ACL, an error is not reported and the ACL is not applied to the SSM range.
Dell Networking OS-recommended best-practices are to congure the standard ACL, and then apply the
ACL to the SSM range. After the SSM range is applied, the changes are applied internally without requiring
clearing of the tree information base (TIB).
When the ACL rules change, the ACL and protocol-independent multicast (PIM) modules apply the new
rules automatically.
When you congure the SSM range, Dell Networking OS supports SSM for congured group range as well
as the default SSM range.
When you remove the SSM ACL, PIM SSM is supported for the default SSM range only.
show ip pim ssm-range
Display the non-default groups added using the SSM range feature.
S5000
Syntax
show ip pim [vrf vrf-name] ssm-range
Defaults none
Command Modes
• EXEC
• EXEC Privilege
PIM-Source Specic Mode (PIM-SSM)
1387