Users Guide
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of the VRF to
congure this setting on that VRF.
NOTE: Applies to specic VRF if input is provided, else applies to Default
VRF.
rp-address (OPTIONAL) Enter the RP address in dotted decimal format (A.B.C.D).
Command Modes EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Added support for VRF. Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.8.1.0 Introduced on the S-Series.
Usage Information This command re-applies the RP mapping logic for all the groups learnt by the node. Any stale information
corresponding to the existing mapping conguration is updated. As a result, the existing BSR cache and the
*,G's are deleted only if these entries are stale.
debug ip pim
View IP PIM debugging messages.
S5000
Syntax
debug ip pim [vrf vrf-name] [bsr | events | group | packet [in | out] |
register | state | timer [assert | hello | joinprune | register]]
To disable PIM debugging, use the no debug ip pim [vrf vrf-name] command or use the
undebug allto disable all debugging command.
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of the VRF to view IP
PIM debugging messages corresponding to that VRF.
NOTE: Applies to specic VRF if input is provided, else applies to Default
VRF.
bsr (OPTIONAL) Enter the keyword bsr to view PIM Candidate RP/BSR activities.
PIM-Sparse Mode (PIM-SM)
1357