Users Guide

spf (OPTIONAL) Enter the keyword spf to display the Shortest Path First information.
database-timer
rate-limit
(OPTIONAL) Enter the keywords database-timer rate-limit to display
the LSA throttling timer information.
Command Modes EXEC Privilege
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage Information The following describes output for the debug ip ospf command shown in the Example below.
Field Description
8:14 Displays the time stamp.
OSPF Displays the OSPF process ID: instance ID.
v: Displays the OSPF version. Dell Networking OS supports version 2 only.
t: Displays the type of packet sent:
• 1 - Hello packet
• 2 - database description
• 3 - link state request
• 4 - link state update
• 5 - link state acknowledgement
l: Displays the packet length.
rid: Displays the OSPF router ID.
aid: Displays the Autonomous System ID.
chk: Displays the OSPF checksum.
aut: States if OSPF authentication is congured. One of the following is listed:
• 0 - no authentication congured
• 1 - simple authentication congured using the ip ospf authentication-
key command
•
2 - MD5 authentication congured using the ip ospf message-digest-
key command
auk: If the ip ospf authentication-key command is congured, this eld
displays the key used.
keyid: If the ip ospf message-digest-key command is congured, this eld
displays the MD5 key
to: Displays the interface to which the packet is intended.
dst: Displays the destination IP address.
netmask: Displays the destination IP address mask.
pri: Displays the OSPF priority
N, MC, E, T Displays information available in the Options eld of the HELLO packet:
• N + (N-bit is set)
• N - (N-bit is not set)
1276
Open Shortest Path First (OSPFv2 and OSPFv3)