Users Guide
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage Information
Use the show qos dcb-map command to display the enhanced transmission selection (ETS) and priority-
based ow control (PFC) parameters used to congure server-facing Ethernet ports. S5000 Ethernet ports
are DCBx-enabled by default.
The following table describes the show qos dcb-map output shown in the example below.
Field Description
State Complete: All mandatory DCB parameters are correctly congured. In progress: The
DCB map conguration is not complete. Some mandatory parameters are not
congured.
PFC Mode PFC conguration in DCB map: On (enabled) or O.
PG Priority group congured in the DCB map.
TSA Transmission scheduling algorithm used by the priority group: Enhanced
Transmission Selection (ETS).
BW Percentage of bandwidth allocated to the priority group.
PFC PFC setting for the priority group: On (enabled) or O.
Priorities 802.1p priorities congured in the priority group.
Example
Dell# show qos dcb-map dcbmap2
State :Complete
PfcMode:ON
--------------------
PG:0 TSA:ETS BW:50 PFC:OFF
Priorities:0 1 2 4 5 6 7
PG:1 TSA:ETS BW:50 PFC:ON
Priorities:3
Related Commands
dcb-map — creates a DCB map to congure PFC and ETS parameters and applies the PFC and ETS
settings on Ethernet ports.
NPIV Proxy Gateway
1239