Users Guide

fcoe-map — creates an FCoE map which contains the parameters used in the communication between servers and a SAN fabric.
show fc switch
Display the switch conguration for Fibre Channel capability.
S5000
Syntax
show fc switch
Parameters None
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage Information
Use the show interfaces fibrechannel command to display information on the Fibre Channel
capability of a switch.
The following table describes the show fc switch output shown in the following example.
Switch Mode Fibre Channel mode of operation of an S5000 switch. Default: NPG (congured as
an NPIV proxy gateway).
Switch WWN Factory-assigned worldwide node (WWN) name of the S5000. The S5000 WWN
name is not user-congurable.
Example
Dell# show fc switch
Switch Mode : NPG
Switch WWN : 10:00:5c:f9:dd:ef:10:c0
Dell#
Related Commands
interface brechannel — congures a Fibre Channel interface on the switch.
show interfaces brechannel — displays the conguration of a Fibre Channel interface.
show qos dcb-map
Display the DCB parameters congured in a specied DCB map.
S5000
Syntax
show qos dcb-map map-name
Parameters
map-name Displays the PFC and ETS parameters congured in the specied map.
1238
NPIV Proxy Gateway