Users Guide
Related Commands
fcoe-map — creates an FCoE map which contains the parameters used in the communication between
servers and a SAN fabric.
show fcoe-map— displays the Fibre Channel and FCoE conguration parameters in FCoE maps.
keepalive
In an FCoE map, enable the monitoring of FIP keepalive messages (if it is disabled).
S5000
Syntax
keepalive
Parameters None
Defaults FIP keepalive monitoring is enabled on Ethernet and Fibre Channel interfaces.
Command Modes FCOE MAP
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage Information
FIP keepalive (FKA) messaging is used to detect if other FCoE devices are reachable.
To remove FIP keepalive monitoring from an FCoE map, enter the no keepalive command.
Related Commands
fcoe-map — creates an FCoE map which contains the parameters used in the communication between
servers and a SAN fabric.
show fcoe-map— displays the Fibre Channel and FCoE conguration parameters in FCoE maps.
priority-pgid
Assign 802.1p priority trac to a priority group in a DCB map.
S5000
Syntax
priority-pgid dot1p0_group-num dot1p1_group-num dot1p2_group-num
dot1p3_group-num dot1p4_group-num dot1p5_group-num dot1p6_group-num
dot1p7_group-num
Parameters
dot1p0_group-num Enter the priority group number for each 802.1p class of trac in a DCB map.
dot1p1_group-num
dot1p2_group-num
dot1p3_group-num
dot1p4_group-num
NPIV Proxy Gateway
1231