Users Guide

Defaults 8 seconds
Command Modes FCOE MAP
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage Information
To delete the FIP keepalive time period from an FCoE map, enter the no fka-adv-erpiod command.
Related Commands
fcoe-map — creates an FCoE map which contains the parameters used in the communication between
servers and a SAN fabric.
show fcoe-map— displays the Fibre Channel and FCoE conguration parameters in FCoE maps.
interface vlan (NPIV proxy gateway)
Create a dedicated VLAN to be used to send and receive Fibre Channel trac over FCoE links between servers and a fabric over an
S5000 NPIV proxy gateway.
S5000
Syntax
interface vlan vlan-id
Parameters
vlan-id Enter a number as the VLAN Identier. The range is 1 to 4094.
Defaults Not congured.
Command Modes CONFIGURATION
Command History
Version 9.0(1.3) Introduced on the S5000 congured as an NPIV proxy gateway.
Usage Information
FCoE storage trac received from servers on an S5000 NPIV proxy gateway is de-capsulated into Fibre
Channel packets and forwarded over FC links to SAN switches in a specied fabric. You must congure a
separate FCoE VLAN for each fabric to which FCoE trac is forwarded. Any non-FCoE trac sent on a
dedicated FCoE VLAN will be dropped.
You congure the association between a dedicated VLAN, which carries FCoE trac from server CNAs over
the NPIV proxy gateway to a SAN fabric in which destination storage arrays are installed, in an FCoE map by
using the fabric id vlan command.
When you apply an FCoE map to a server-facing Ethernet port, the port is automatically congured as a
tagged member of the FCoE VLAN.
For more information about VLANs and the commands to congure them, refer to the Virtual LAN (VLAN)
Commands section of the Layer 2 chapter.
Example (Single
Range)
Dell(conf)#interface vlan 10
Dell(conf-if-vl-3)#
1230
NPIV Proxy Gateway