Users Guide
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage Information
The FCF priority you assign to an S5000 is used by server CNAs to select an upstream FCF to use for a
fabric login (FLOGI).
To remove a congured FCF priority from an FCoE map, enter the no fcf-priority command.
Related Commands
fcoe-map — creates an FCoE map which contains the parameters used in the communication between
servers and a SAN fabric.
show fcoe-map— displays the Fibre Channel and FCoE conguration parameters in FCoE maps.
feature fc
Enable Fibre Channel capability on the S5000.
S5000
Syntax
feature fc
Defaults The S5000 is not enabled to operate in Fibre Channel mode.
Command Modes CONFIGURATION
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage Information
Use this command to congure the S5000 to interoperate with Fibre Channel devices in SAN fabrics.
Enter the no feature fc command to disable the Fibre Channel command-line interface and free
memory resources allocated to Fibre Channel operation.
Example
Dell(conf)#feature fc
Related Commands
show interfaces brechannel — displays the conguration of a Fibre Channel interface.
fka-adv-period
In an FCoE map, congure the time interval used to transmit FIP keepalive (FKA) advertisements.
S5000
Syntax
fka-adv-period seconds
Parameters
seconds Enter the time period (in seconds) used to send FIP keepalive messages to peer
devices. The range is from 8 to 90 seconds.
NPIV Proxy Gateway
1229