Users Guide

Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.7(0.0) Introduced on the S4810, S4820T, S5000, S6000, and Z9000 switches.
ipv6 nd ra-guard policy
Dene the RA guard policy name and enter the RA guard policy list conguration mode.
Syntax
ipv6 nd ra-guard policy policy-name
Parameters
policy policy-name Enter the keyword policy then the policy-name. The policy name allows a
maximum of 140 characters.
Defaults none
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.7(0.0) Introduced on the S4810, S4820T, S5000, S6000, and Z9000 switches.
Related Commands ipv6 nd ra-guard enable — Allows you to congure the RA guard related commands.
managed-cong-ag
Set the managed address conguration ag.
Syntax
managed-config-flag {on | off}
To clear the ag, use the no managed-config-flag {on | off} command.
Parameters
on Enter the keyword on to set the managed-cong-ag value as ON.
o Enter the keyword off to set the managed-cong ag value as OFF.
Defaults none
Command Modes POLICY LIST CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
1200
Neighbor Discovery Protocol (NDP)