Users Guide

Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.1 Introduced on the S4810.
E-Series legacy
command
Usage Information Network administrators use static mroutes to control the reach-ability of the multicast sources. If a PIM-
registered multicast source is reachable using static mroute as well as unicast route, the distance of each
route is examined and the route with shorter distance is the one the PIM selects for reach-ability.
NOTE: The default distance of mroutes is zero (0) and is CLI congurable on a per route basis.
Example
Dell#show ip rpf
RPF information for 10.10.10.9
RPF interface: Te 3/4
RPF neighbor: 165.87.31.4
RPF route/mask: 10.10.10.9/255.255.255.255
RPF type: unicast
IPv6 Multicast Commands
.This section describes the IPv6 multicast commands.
ip multicast-limit
To limit the number of multicast entries on the system, use this feature.
S5000
Syntax
ip multicast-limit [vrf vrf-name] limit
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of the VRF to limit the
number of multicast on the VRF.
Multicast
1191