Users Guide

mac learning-limit reset
Reset the MAC address learning-limit error-disabled state.
Syntax
mac learning-limit reset
Defaults none
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
7.5.1.0 Introduced on the E-Series.
show cam mac stack-unit
Display the content addressable memory (CAM) size and the portions allocated for MAC addresses and for MAC ACLs.
Syntax
show cam mac stack-unit unit_number port-set port-pipe count [vlan vlan-id]
[interface interface]
Parameters
stack-unit
unit_number
(REQUIRED) Enter the keyword linecard followed by a stack member number
to select the linecard for which to gather information. The S-Series range is 0 to 1.
port-set port-pipe (REQUIRED) Enter the keywords port-set followed by a Port-Pipe number to
select the Port-Pipe for which to gather information. The range is 0 or 11.
address mac-addr (OPTIONAL) Enter the keyword address followed by a MAC address in the
nn:nn:nn:nn:nn:nn format to display information on that MAC address.
dynamic (OPTIONAL) Enter the keyword dynamic to display only those MAC addresses
learned dynamically by the switch.
Layer 2
1099