Users Guide

Version 8.3.19.0 Introduced on the S4820T.
Version 8.4.2.1 Introduced on the C-Series and S4810.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
show ip bgp ipv6 unicast neighbors
Allows you to view the information exchanged by BGP neighbors.
Syntax
show ip bgp ipv6 unicast neighbors [ipv6-address prefix-length [advertised-
routes | dampened-routes | detail | flap-statistics | routes]]
Parameters
ipv6-address prex-
length
(OPTIONAL) Enter the IPv6 address in the x:x:x:x::x format then the prex length
in the /x format. The range is from /0 to /128.
NOTE: The :: notation species successive hexadecimal elds of zeros.
advertised-routes (OPTIONAL) Enter the keywords advertised-routes to view only the routes
the neighbor sent.
dampened-routes (OPTIONAL) Enter the keywords dampened-routes to view information on
dampened routes from the BGP neighbor.
ap-statistics (OPTIONAL) Enter the keywords flap-statistics to view ap statistics on
the neighbor’s routes.
detail (OPTIONAL) Display detailed neighbor information.
routes (OPTIONAL) Enter the keyword routes to view only the neighbor’s feasible
routes.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.4.2.1 Introduced on the C-Series and S4810.
Version 7.5.1.0 Added the detail option and added information to the output.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
Usage Information The following describes the show ip bgp ipv6 unicast neighbors command shown in the
Example below.
1008
IPv6 Border Gateway Protocol (IPv6 BGP)