Users Guide

summary Display a summary of RPF routes.
Command Modes EXEC
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant FTOS
Command Line Reference Guide.
The following is a list of the FTOS version history for this command.
Version Description
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.10.0 Introduced on the S4810.
show ip bgp ipv6 unicast
View the current MBGP route table.
C-Series, E-Series, S4810
Syntax
show ip bgp ipv6 unicast [network [network-mask] [length]]
Paramters
network (OPTIONAL) Enter the network address (in dotted decimal format) of the BGP
network to view information only on that network.
network-mask (OPTIONAL) Enter the keywords network mask (in slash prex format) of the
BGP network address.
longer-prexes (OPTIONAL) Enter the keywords longer-prefixes to view all routes with a
common prex.
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 8.4.2.1 Introduced on the C-Series and S4810.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
Usage Information The following describes the show ip bgp ipv6 unicast command shown in the Example below.
Field Description
Network Displays the destination network prex of each BGP route.
Next Hop Displays the next hop address of the BGP router. If 0::0/0 is listed in this column,
local routes exist in the routing table.
Metric Displays the BGP route’s metric, if assigned.
LocPrf Displays the BGP LOCAL_PREF attribute for the route.
Weight Displays the route’s weight.
IPv6 Border Gateway Protocol (IPv6 BGP)
1001