Users Guide

Parameters
connected Enter the keyword connected to redistribute routes from physically connected
interfaces.
static Enter the keyword static to redistribute manually congured routes. These
routes are treated as incomplete routes.
route-map map-
name
(OPTIONAL) Enter the keywords route-map followed by the name of an
established route map. Only the following ROUTE-MAP mode commands are
supported:
• match ipv6 address
• match ipv6 next-hop
• match ipv6 route-source
• set ipv6 next-hop
If the route map is not congured, the default is deny (to drop all routes).
Defaults Not congured.
Command Modes ROUTER BGPV6-ADDRESS FAMILY
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.4.2.1 Introduced on the C-Series and S4810.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
Usage Information
If you do not congure the default-metric command, in addition to the redistribute command, or
there is no route map to set the metric, the metric for redistributed static and connected is “0”.
To redistribute the default route (0::0/0), congure the neighbor default-originate command.
Related Commands neighbor default-originate – injects the default route.
show ipv6 mbgproutes
Display the selected IPv6 MBGP route or a summary of all MBGP routes in the table.
Syntax
show ipv6 mbgproutes ipv6-address prefix-length | summary
Parameters
ipv6-address prex-
length
(OPTIONAL) Enter the IPv6 address in the x:x:x:x::x format then the prex length
in the /x format. The range is from /0 to /128.
NOTE: The :: notation species successive hexadecimal elds of zeros.
1000
IPv6 Border Gateway Protocol (IPv6 BGP)