Manualshelf

Service Manual

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S5000
921922923924925926927928929930
Configuring Interfaces for Layer 2 Mode
To configure and enable interfaces in Layer 2 mode, use the following commands.
All interfaces on all bridges that participate in Rapid Spanning Tree must be in Layer 2 and enabled.
Figure 117. Example of Configuring Interfaces for Layer 2 Mode
1 If the interface has been assigned an IP address, remove it.
INTERFACE mode
no ip address
2 Place the interface in Layer 2 mode.
INTERFACE mode
Rapid Spanning Tree Protocol (RSTP) 921