Service Manual

Resetting an Interface to its Factory
Default State
You can reset the configurations applied on an interface to its factory default state. To reset the configuration,
perform the following steps:
1 View the configurations applied on an interface.
INTERFACE mode
show config
Dell(conf-if-te-1/5)#show config
!
interface TenGigabitEthernet 1/5
no ip address
portmode hybrid
switchport
rate-interval 8
mac learning-limit 10 no-station-move
no shutdown
2 Reset an interface to its factory default state.
CONFIGURATION mode
default interface interface-type]
Dell(conf)#default interface tengigabitethernet 1/5
3 Verify the configuration.
INTERFACE mode
show config
Dell(conf-if-te-1/5)#show config
!
interface TenGigabitEthernet 1/5
no ip address
shutdown
All the applied configurations are removed and the interface is set to the factory default state.
Enabling Energy Efficient Ethernet
Energy Efficient Ethernet (EEE) is an IEEE 802.3 az standard that reduces power consumptions on Ethernet
ports. EEE stops the transmission when there is no data to be transmitted and resumes the transmission at the
arrival of new packets. You can enable EEE only on ten Gigabit native or optional module copper ports.
1 To enable EEE, use the eee command.
Interfaces 475