Reference Guide

VLT DOMAIN PROXY GW LLDP mode
Dell(conf-vlt-domain-proxy-gw-lldp)#peer-domain-link port-channel interface
exclude-vlan vlan-range
4. Display the VLT proxy gateway configuration.
EXEC mode
Dell#show vlt-proxy-gateway
Configuring a Static VLT Proxy Gateway
You can configure a proxy gateway in VLT domains. A proxy gateway allows you to locally route the
packets that are destined to an L3 endpoint of the other VLT domain.
To configure the static proxy gateway, perform the following:
1. Enable VLT on a switch, then configure a VLT domain and enter VLT-Domain Configuration mode.
CONFIGURATION mode
Dell(conf)#vlt domain domain-id
2. Configure the static proxy gateway.
VLT DOMAIN mode
Dell(conf-vlt-domain)#proxy-gateway static
3. You can configure the remote MAC address of a VLT peer for a static proxy gateway and exclude a
VLAN or a range of VLANs from proxy routing. This parameter is for a static proxy gateway
configuration.
VLT DOMAIN PROXY GW STATIC mode
Dell(conf-vlt-domain-proxy-gw-static)#remote-mac-address mac-address
exclude-vlan vlan-range
4. Display the VLT proxy gateway configuration.
EXEC mode
Dell#show vlt-proxy-gateway
VLT Proxy Gateway
993